Let the floor cloth air dry, as putting it in the dryer could cause it to shrink. Pull both ends of the floor cloth off of the head of the mop and rinse it in water after each use. 99 When purchased online BISSELL CrossWave HydroSteam Plus Steam Cleaner - 3515 Bissell 233 299.
#Bissell steam shot spraying water full
The steamer should never be stored with water in the tank. Delivers up to 45 minutes of steam on a full tank of water. Unplug the cleaner and pour the remaining water out of the tank by removing the fill cap and dumping the water into a sink. Resume cleaning by turning the cleaner on again. Refill the water tank when the cleaner stops emitting steam by turning off the cleaner, unplugging the power cord and repeating Steps 1 and 2.
Do not leave the steamer in one spot for longer than 15 seconds or it might damage the floor. The cleaner will emit a constant stream of steam as long as there is water in the tank.ĭisinfect an area of the floor by holding the steamer over it for approximately eight seconds. Steam will start coming out of the cleaner when it is ready for use.Ĭlean your floor by pushing and pulling the steamer over the floor as if you were using a standard hard floor cleaner. Press the power button to preheat the steamer, which takes approximately three minutes. Using excessively hot water or microwaving the clean water tank can. Reinsert the tank by firmly pushing it back into place leaving no gaps. If no water comes out, replace the Clean Water Tank > Go to Parts & Supplies. Over a sink, push up on the red valve of clean water tank. Plug the power cord into an electrical outlet and set the steamer on the preheating tray. If damaged, replace the Clean Water Tank > Go to Parts & Supplies.
0 kommentar(er)
